SATO GL 4xxe Series Programming Reference Guide

Unit 4: Standard Command Codes
SATO GL4xxe SBPL Programming Reference Page 4-67
PRINT LENGTH, EXPANSION
FUNCTION
To increase the maximum print length (in feed direction) for a label.
FORMAT
<ESC>EX0 Sets the print length to maximum
<ESC>AR Resets the maximum print length to 7" (178 mm)
Must follow the Start Code command within it is own separate data stream.
EXAMPLE
<ESC>A
<ESC>EX0
<ESC>Z
<ESC>A
<ESC>H0050<ESC>V0100<ESC>WB1EXPAND TO:
<ESC>H0050<ESC>V2700<ESC>WB1MAX INCHES
<ESC>Q1
<ESC>Z
<ESC>A
<ESC>AR
<ESC>Z
OUTPUT
(4-43)
NOTES
“EX0” is effective until “AR” is sent to reset the printer to its standard print length, or
until the printer is re-powered.
When this command is used with the Store Form Overlay (<ESC>&) command the
form length cannot exceed the maximum specified.
If a job contains elements out of the memory range, it is ignored.
If the Forms Overlay (<ESC>&) command is used with Expanded Memory to expand
the print area, the Form Overlay length is still limited to the maximum.

SATO GL 4xxe Series Specifications

General

Brand	SATO
Model	GL 4xxe Series
Category	Barcode Reader
Language	English