EasyManuals Logo

SATO GL 4xxe Series Programming Reference Guide

SATO GL 4xxe Series
170 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #97 background imageLoading...
Page #97 background image
Unit 4: Standard Command Codes
SATO GL4xxe SBPL Programming Reference Page 4-59
EEPROM SETUP
FUNCTION
Registers the operation of the printer in EEPROM.
FORMAT
<ESC>PG
Place immediately after <ESC>A.
EXAMPLE
<ESC>A
<ESC>PG
<ESC>Z
OUTPUT
This command does not result in printer output.
NOTES
This command is not necessary with normal label printing. The operational settings
specified are still in effect after powering off the printer.
Refer to Appendix: Reference Table 29 for additional information.
FLASH ROM SETUP
FUNCTION
Registers the operation of the printer in EEPROM.
FORMAT
<ESC>PC
Place immediately after <ESC>A.
EXAMPLE
<ESC>A
<ESC>PC26,1
<ESC>Z
OUTPUT
This command does not result in printer output.
NOTES
Go to the Advanced Mode or Service Mode for configuration. These command setting
will remain in effect after powering off the printer.
The entire or partial parameter entries is omissible by using commas for total settings.
Any commas that are omitted will result in those settings remaining as default.
Refer to Appendix: Reference Table 30 for additional information.

Table of Contents

Other manuals for SATO GL 4xxe Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SATO GL 4xxe Series and is the answer not in the manual?

SATO GL 4xxe Series Specifications

General IconGeneral
BrandSATO
ModelGL 4xxe Series
CategoryBarcode Reader
LanguageEnglish

Related product manuals