Unit 4: Standard Command Codes
SATO GL4xxe SBPL Programming Reference Page 4-53
CUT, JOB
FUNCTION
Regulates label cutting when using a cutter assembly with the printer. This command
allows the cutting of a multi-part tag or label at a specified interval within a print job.
FORMAT
<ESC>~aaaa
aaaa = Number of labels to print between each cut (1 to 9999)
Place following the Print Quantity command <ESC>Q.
EXAMPLE
<ESC>A
<ESC>H0020<ESC>V0020<ESC>XB1ABC<ESC>Q3
<ESC>~0002
<ESC>Z
OUTPUT
This set of commands will print 6 labels (3 x 2) with two labels between each cut.
(4-38)
NOTES
The optional label cutter must be installed and the printer configured for its use for this
function to be valid. If the cut value is (a = 0), the cutter is inactive.
A “~” (tilde) character or <NUL> (ASCII 00 Hex) character can be used in this
command. It is recommended that the “~” be used whenever possible.
When using the Cutter command, the total number of labels printed is the product of
the cut value and the print quantity.
To Next Page
Loading...
Need help?
General
