SATO GL 4xxe Series Programming Reference Guide

Unit 4: Standard Command Codes
SATO GL4xxe SBPL Programming Reference Page 4-22
PRINT POSITION COMMANDS
MEDIA SIZE
FUNCTION
To set the size of the media.
FORMAT
<ESC>A1aaaabbbb
aaaa = Label Height in dots (0 to Hmax)
bbbb = Label Width in dots (0 to Vmax)
Place in a separate data stream to the printer.
INPUT
<ESC>A
<ESC>A108321424
<ESC>Z
OUTPUT
This command does not result in printer output. It is used to automatically adjust the
offset values for the size of label being used. The sample command stream specifies
a label 832 dots wide by 1424 dots long.
NOTES
The Base Reference point is always the on the right (looking at the front of the printer)
side of the print head. This command adjusts the Base Reference Point to correspond
with the right edge of the loaded media.
If the label size is changed, then this command must be re-specified to center the print
image on the label.
All eight variables “aaaa” and “bbbb” must be included in this command.

SATO GL 4xxe Series Specifications

General

Brand	SATO
Model	GL 4xxe Series
Category	Barcode Reader
Language	English