SATO GL 4xxe Series Programming Reference Guide

Unit 6: Bi-Directional Communications
SATO GL4xxe SBPL Programming Reference Page 6-7
DESIGNATION OF SWITCHING STATUS 5 RETURN (ESC + PL)
This command switching the communication protocol. Avoid the inclusion and use of this
command in the print data (<ESC>A - <ESC>Z). The specified contents are still in effect after the
printer is powered off.
This command is not available for the protocol that is not supported by the current interface. If
using LAN interface or changing from driver protocol (or vice versa), repower on the printer.
Normal transmission and reception of data cannot be performed without repowering.
DESIGNATION OF STATUS 5 RETURN CHECK (ESC + CR)
This command provides setup of the BCC Check function of Status 5 Return and the item
number. Avoid the inclusion and use of this command in the print data (<ESC>A - <ESC>Z).
PARAMETER (ESC + PL + a
a Switchover Designation - 0: Ready/Busy
1: Xon/Xoff
2: Status 2 Return
3: Status 3 Return
4: Driver Protocol
5: Status 5 Return
PARAMETER (ESC + PL + a
a BCC Check - 0: Not Available
1: Available
b Item Number Check - 0: Not Available
1: Available

SATO GL 4xxe Series Specifications

General

Brand	SATO
Model	GL 4xxe Series
Category	Barcode Reader
Language	English