Unit 3: Command Quick Reference
SATO GL4xxe SBPL Programming Reference Page 3-8
BVa,b,c, ddddddddd,eee,
f f f,gg..g
Maxicode. Prints 2-D Maxicode symbols per AIM I.S.S. specification.
a = Position of symbol within the set
b = Total number of symbols in the set
c=Mode
dd..d = 9 digit numeric Postal Code
eee = 3 digit numeric Country Code
f f f = 3 digit numeric Service Class
gg..g = Data, terminated by <ESC>
BWaabbb Bar Codes. Expansion. Works together with the BT command to specify
an expansion factor and the bar code height for the particular symbol being
printed.
aa = Expansion factor by which the width of all bars and spaces
is increased (01 to 12)
bbb = Bar height by dot (004 to 999 dots)
BXaabbccddeeefffghh Data Matrix. Data Format. Specifies the format of the Data Matrix 2-D
symbology.
aa = Format ID (01 to 06, If ECC200 is selected (bb=20) this
field is ignored.
bb = Error correction level (00, 05, 08,10,14, 20 or 200. All other
values processed as 00.
cc = Horizontal cell size (03 to 12 dots/cell)
dd = Vertical cell size (03 to 12 dots per cell)
eee = Cells per line. Use 000 for optimized symbol.
fff = Cell lines. Use 000 to optimize.
g = Mirror image
0: Normal Print
1: Reverse Print
hh = Guide cell thickness (01 to 15) 01 indicates normal type.
C Repeat Label. Prints a duplicate of the last label printed.
CCa Card, Slot for Use. Selects the memory area for all following expanded
memory commands.
a
= Memory Area 1
b
= Memory Area 2
COMMAND QUICK REFERENCE
INSTRUCTION DESCRIPTION
To Next Page
Loading...
Need help?
General
