Configuration and Interface set up
WS4-DT/TT-r01-12.1.17-OM-RS
50
SBPL Parameter display
It is the media sensor you are using. It includes I-MARK,
GAP and None. When you perform media calibration, the
sensor is set to the one you select.
Thermal Transfer Your printer uses the ribbon sensor to
detect the ribbon for Thermal Transfer (TT) operation.
Direct Thermal Disables the ribbon sensor, for Direct
Thermal (DT) use.
It defines the action of the FEED button.
Feed Your printer feeds a blank label each time the
button is pressed.
Reprint Your printer reprints the last label each time the
button is pressed.
Enable Your printer checks broken pins on the printhead
automatically once your printer is turned on.
Disable Disable the auto head check.
ON (Power on) Your printer automatically calibrates
media using a media sensor once it restarts or is turned on.
ON (Head close) Your printer automatically calibrates
media using a media sensor every time you close the print
module when the printer is turned on.
ON (Power on and Head close) Your printer
automatically calibrates media using a media sensor after
power on and every time you close the print module when
the printer is turned on.
OFF You need to manually calibrate media using a media
To Next Page
Loading...
