SATO WS408DT - Page 57

Configuration and Interface set up
WS4-DT/TT-r01-12.1.17-OM-RS
51
Property Name
Description
sensor as you change the media, or your printer won’t
work properly.
Reprint After Error
Enable The label is reprinted as soon as the error
condition is corrected.
Disable Disable the reprint after error.
Print Darkness
Adjust the darkness relative to the current darkness
setting. The range is +1~ +5, and the value is adjustable in
increments of ± 1.
Print Speed
Determine the media speed during printing. The range is
+2 ~ +6, and the value is adjustable in increments of ± 1 ips.
Stop Position for
Cutter
Blank Printer does not install cutter module.
Head Position Stop the paper forward on the head
position.
Cutter Position Stop the paper forward on the cutter
position.
Stop Position for
Dispenser
Blank Printer does not install dispenser module.
Head Position Stop the paper forward on the head
position.
Dispense Position Stop the paper forward on the
dispenser position.
Tear Off Wait Time
Your printer moves the paper forward in a predefined time
after printing, and pulls the paper back in a predefined
length once the printing begins again.
Zero Slash
Display a zero with or without a slash through it.
Unit(Label)
Change the unit of label to millimeters or inches.
Width
Set the print width.
Height
Set the length of the label when using continuous media.
Unit(Position
Adjustment)
Change the unit of Position Adjustment to millimeters,
inches or dots.
Horizontal Offset
Move the print position horizontally. The positive number
is left, and the negative number is right.
Vertical Offset
Move the print position vertically. The positive number is
forward, and the negative number is backward.
Continuous Offset
Adjust the continuous offset at which the continuous label
is cut.