SATO WS408DT - Page 58

Configuration and Interface set up
WS4-DT/TT-r01-12.1.17-OM-RS
52
Property Name
Description
Tear Off Offset
Adjust the rest position of the media after a label is
printed, which changes the position at which the label is
torn or cut.
Cutter/Dispenser
Offset
Adjust the cutter/dispenser offset position at which the
label is dispensed or cut.
Status
This is communication protocol for SBPL. Status 3 is Enq
response and Status 4 is for the communication via driver.
Nonstandard
protocol
When you use non standard code, you can set the codes in
this section.