SATO WS408DT - Page 60

Configuration and Interface set up
WS4-DT/TT-r01-12.1.17-OM-RS
54
Property Name
Description
media using a media sensor every time you close the print
module when the printer is turned on.
ON (Power on and Head close) Your printer
automatically calibrates media using a media sensor after
power on and every time you close the print module when
the printer is turned on.
OFF You need to manually calibrate media using a media
sensor as you change the media, or your printer won’t
work properly.
Reprint After Error
Enable The label is reprinted as soon as the error
condition is corrected.
Disable Disable the reprint after error.
Print Darkness
The range is 0 ~ +30, and the value is adjustable in
increments of ± 1.
Print Speed
Determine the media speed during printing. The range is
+2 ~ +6, and the value is adjustable in increments of ± 1 ips.
Unit(Label)
mm Change the unit of label to millimeter or inches.
Width
Set the print width.
Height
Set the length of the label when using continuous media.
Unit(Position
Adjustment)
Change the unit of Position Adjustment to millimeter, inch
or dots.
Horizontal Offset
Move the print position horizontally. The positive number
is left, and the negative number is right.
Vertical Offset
Move the print position vertically. The positive number is
forward, and the negative number is backward.
Tear Off Offset
Adjust the rest position of the media after a label is
printed, which changes the position at which the label is
torn or cut.
Cutter Offset
Adjust the cutter offset position at which the label is peel
or cut.