●
If you don’t have a static IP address, make sure DHCP is enabled and click
Send.
5. After your printer restarts, click Get to get the TCP/IP information of your
printer. If you are using a static IP address, you’ll get the same TCP/IP settings
as it is in the previous step; if you are using DHCP, The DHCP server will
automatically populate the IP Address, Subnet Mask and Gateway boxes
under Current TCP/IP.
6. In the Input/Output Port list, click LAN, and click Setting.
7. In the Setting LAN dialog box, do one of the following to configure your IP
address:
●
If you are using a static IP address,
in the IP Address box, enter the IP
address under TCP/IP in the LAN
tab, and then click OK.
To Next Page
Loading...
