Sauer WP 33 L - Filling with Oil

Transport and Installation
WP33L_BA_K1_12_en_08.fm
41
5.6 Filling with oil
1. Unscrew oil filler (red).
2. Fill with oil and check the oil level with the dipstick (red).
3. Put dipstick back and replace the oil filler plug.
Note!
Unless otherwise ordered, Sauer compressors are delivered
without oil.
Dipstick
Oil filler
Danger
The compressor's crankcase oil sump must be filled with oil be-
fore initial operation!
Use recommended lubricating oil (see Chapter 10: “Lubricant
Table”).
Note the amount of oil needed (see Chapter 4: “Technical Spe-
cification”).
Note!
Only fill to the upper mark on the oil level indicator. If over-filled
the oil consumption of the compressor will increase.