Maintenance
WP33L_BA_K1_12_en_08.fm
55
8.5 Oil change
1. Put oil catchpan of sufficient size under the Sump oil drain as-
sembly (sufficient capacity to hold the complete oil fill, see
Chapter 4 “Technical Specification”).
2. Remove the oil drain plug.
3. Wait until all oil is drained.
4. Replace the oil drain plug.
5. Unscrew oil filler (red).
6. Fill the oil and check the level with the dipstick.
The level should be between the upper and lower mark on the
dipstick.
7. Put dipstick back and replace the oil filler.
Note!
Only use oil as recommended in the Lubricant Table (see Chap-
ter 10).
Oil drain plug
Dipstick
Oil filler
To Next Page
Loading...
