52
WP33L_BA_K1_12_en_08.fm
8.3 Maintenance schedule
Instructions for
the maintenance
schedule
• Use the maintenance schedule as a master template or copy
the respective page from the document and save it as a sepa-
rate file under a suitable name. Use the maintenance schedule
as a guide for evidence that work has been carried out.
• Regularly check the maintenance schedule to see which main-
tenance intervals, depending upon the number of operating
hours, are due. The intervals are shown in the table's column
headers.
• Check the column of each maintenance interval to see what
maintenance work is to be carried out at the end of each main-
tenance interval. The required tasks are indicated by check
boxes. The description for the tasks is shown in the first co-
lumn.
• Carry out all maintenance work for an interval and tick the ap-
propriate check boxes of the maintenance schedule.
Then enter operating hours count, date and your signature.
• When beginning a new maintenance schedule
– enter: main specifications, date of commissioning, number
of maintenance schedule, current date and operating hours
count
– tick: beginning after commissioning/after major overhaul
Danger!
For all maintenance work Chapter 8.4 “Table of tightening
torques” must be observed for identified screws, bolts and nuts.
Note!
The maintenance intervals specified in the maintenance schedu-
le must be adhered to. Shortening the maintenance intervals is
of no advantage with regard to operating performance or service
life of the Sauer compressor.
Note!
We recommend to carry out an inspection (functional check) by
authorised persons at least once a year.
Note!
After 4,000 operating hours the maintenance schedule begins all
over again.
The major overhaul after 8,000 operating hours shall be carried
out by personnel authorised by Sauer.
To Next Page
Loading...
