Maintenance
WP33L_BA_K1_12_en_08.fm
67
7. Take the crankshaft out.
8. Check crankshaft bearings, replace if worn. If necessary use
new shaft seal.
9. Mount crankshaft.
10. Fit connecting-rods, see chapitel 8.14 “Replacing connecting
rods“.
11. Install bearing housing. Use new gaskets.
bearing bracket
crankshaft
crankshaft bearing
Note!
Only replace the crankshaft lip seal if the bearing housing and
crankshaft are removed!
shaft seal
bearing bracketcrankcase
To Next Page
Loading...
