29
SBS-6500 User Manual
Storage Battery Systems, LLC.
Low voltage judgment is based on absolute value. Therefore a measurement of reverse
polarity of test probes also would be valid. Data is saved as absolute values.
4.2. Limit Function Operation Procedure
1) Limit Function Selection
① In impedance measurement mode (Ω), select key.
② At limit setting mode, set-up limit value at key
or enter the desired values and press to activate.
③ Press key or key to complete limit setting.
④ After setting, mode is switched back to measurement mode. Upper right corner of the
LCD screen will show the actual limit value set.
⑤ After measurements are completed, the limit function can be released by pressing
and press key. The limit settings are released and the
limit set points disappear from the upper right corner of LCD screen.
2) Direct Input of LIMIT values
① In limit setting mode, press key.
② Use the direction keys (left/up/down/right) and encoder switch to set limit values.
③ After values are set, press key to activate the new settings.
④ After setting or selection is done, press the key to convert to
measurement mode.
⑤ On measurement screen. Limit values are displayed in upper right of LCD screen.
To Next Page
Loading...
