25
SBS-6500 User Manual
Storage Battery Systems, LLC.
4) Temperature
Temperature measurements are a subsidiary measurement function in resistance
measurement or voltage measurement. While measuring resistance or voltage,
temperature measurements are recorded from the temperature sensor installed inside of
the (-) pin probe or (-) clamp.
Measured temperature indicates battery terminal contact temperature but not the internal
battery temperature or electrolyte temperature.
℉ or ℃ is set-up in the menu (press key)
3.4. Auto Hold / Record
1) Auto Hold (A Hold)
Auto hold-auto record mode is the factory default mode. The tester is always in
auto hold-auto record mode when the SBS-6500 is first powered on.
Press the key to enter the no record mode. To return to auto mode, press the
key again.
If auto hold is set, is displayed near the top left of the LCD screen.
When measurement data shows “----”, auto hold did not activate
Auto hold and auto record always work together. When auto hold works, the measured
data is automatically recorded at the selected record memory location.
To Next Page
