81
SBS-6500 User Manual
Storage Battery Systems, LLC.
14.2. Fuse Replacement
[Warning]
To avoid electrical shock or bodily injury, remove any input signal from the test probes
before replacing the Fuse. Fuse should be replaced only with a proper rated fuse.
[Replacement Procedure]
① Power OFF the SBS-6500.
② Disconnect test probes from battery terminals.
③ Remove holster case.
④ Open tilt stand and remove the two battery compartment cover screws.
⑤ Unscrew the screw at lower area of bottom case.
⑥ Open the bottom of the case.
⑦ Remove Used Fuse and replace with new fuse.
⑧ Reassemble in the reverse order of above steps.
14.3. Battery Replacement
[Warning]
To avoid electric shock or bodily injury, remove any input signal on test probes before
replacing the batteries. Batteries should be replaced only with the same type of Battery
Packs supplied with the SBS-6500.
[Replacement Procedure]
① Power Off the SBS-6500
② Disconnect any test probes, test Leads, temperature probes, AC power adapter, USB
cable from the unit.
③ Remove holster case.
④ Open tilt stand and remove the screws from the two battery covers.
To Next Page
Loading...
