7
SBS-6500 User Manual
Storage Battery Systems, LLC.
Precautions for Measurements
To prevent Electric Shock Hazard, please pay attention to the following precautions:
When measuring internal resistance (impedance), the battery v oltage should not
exceed 100V DC. When measuring DC Voltages, Input voltage on test leads should not
exceed 300V DC.
Do not measure AC voltages. Unit is designed for DC voltage measurement only.
Proper polarity of battery test probes (for internal resistance, voltages), and proper
connection of the USB Cable (for PC communication).
Pay special attention to the possibility of a spark when connecting the test leads to the
battery. DO NOT TEST in hazardous locations with flammable or explosive gases
present.
Cautions for Test Probes
For safe and accurate measurements, use only the battery test probes supplied with the
SBS-6500.
To prevent failure of breaking wires, do not pull or fold the test probe cables.
Tips of test probes are sharp, use care to prevent injury.
Do not use excessive force which could damage the test probes.
To Next Page
Loading...
