OPM 520 en-GB 27
© Scania CV AB 2018, Sweden
Alarm list
Filtering alarms
In the alarm list, the alarms can be filtered in 3
different groups:
• All alarms
• Display alarms
• Diagnostics
Main display
You activate the different filters by pressing the
respective section at the bottom of the display.
On line 2 in the alarm list, the filter which is ac-
tive is displayed.
Auxiliary display
Press Alarm views. In the dialog box, select the
group you wish to be displayed.
If more than one engine is connected to the sys-
tem, you can choose the engine you wish to see
alarms for by pressing Engine Views.
Turning off the buzzer during
an alarm
The buzzer is switched off when the alarm list is
opened. If the buzzer begins to sound when the
alarm list is open, you can switch it off by press-
ing Acknowledge.
Acknowledging 1 alarm
In the alarm list:
• Select the alarm to be acknowledged. If there
is more information to display the row will be
extended.
• Press Acknowledge.
Acknowledging all alarms
In the alarm list:
• Keep the Acknowledge button depressed for 1
second.
Active alarms will remain in the alarm list.
Alarms from safety device unit
If the alarm is generated via the safety device
unit, it must be acknowledged in both the safety
device unit and on the main display.
Ready
Alarm list
Acknowledge
Panel Alarms Engine Diag.
All Alarms
2: Throttle Position
383 138
Alarm list in the main display.
Engine #1 - Ready
Alarm list
Acknowledge Engine Views
Alarm Views
All Alarms
2: Throttle Position
Source
Engine #1
383 139
Alarm list in auxiliary display.
To Next Page
Loading...