OPM 520 en-GB 6
© Scania CV AB 2018, Sweden
System overview
Description of component
parts
Main display
The main display is the main component in the
control system. Values from the engine sensors
are shown on the display. Commands and other
user functions are also carried out on the main
display.
Contact an authorised Scania workshop if the
main display needs to be configured.
Auxiliary display
The auxiliary display, which is optional, shows
the same things as the main display, with the
same user interface.
The auxiliary display does not need configuring,
as it loads the configuration from the main dis-
play which it is connected to. If the configuration
of the main display has been changed, the auxil-
iary display adapts automatically to the new con-
figuration. Therefore, it is easy to supplement the
control system with an auxiliary display after-
wards.
Network switch
A network switch is only required if more than
1 auxiliary display is connected to the control
system. The displays can then be connected to-
gether via a network cable.
Scania recommends using a network switch, in
order to make it simpler to expand the control
system and connect a computer.
To Next Page
Loading...