01:01-02
©
Scania CV AB 1997 37
Program 96
11. Check that the piston cooling nozzles are in
good condition and fully open. Blow clean
with compressed air, if necessary.
12. Fit the piston cooling nozzle and tighten the
banjo bolt to 23 Nm.
Note The piston cooling nozzle must not
be damaged.
If the jet of oil does not strike the
piston in the right place, there could
be a danger of engine breakdown.
Damaged nozzles must be changed.
13. Fit the oil sump.
14. Fit the cylinder head.
Tighten the cylinder head bolts as described
in the Cylinder head section.
To Next Page
Loading...
Need help?
General
