Mistral Operating Instructions
Part No. SCAZ037980 v6.0.2 18 E&OE
Exiting sweep mode/stopping the auxiliary engine
1. Press the suction fan switch to stop the fan. The suction fan symbol on the LCD monitor will change from GREEN to GREY .
2. Move the Multi-Function Switch (located on the lower extension of the auxiliary control panel) to the ‘Sweep Master Switch OFF position. All active sweep
systems will stop and retract.
If the Multi-Function Switch is not returned to the OFF position at this point, the sweeping equipment will not function upon any subsequent resumption of Sweep
Mode until it has been first moved to the OFF position and then returned to the ON position.
3. Allow the auxiliary engine to idle for approximately two minutes and then press the System Start/Stop switch . The engine will stop and the sweeping
equipment symbols displayed on the LCD monitor truck graphic will extinguish, to show that Sweep Mode is OFF.
Engaging the reduction gearbox (scarab option only)
On vehicles fitted with a Scarab reduction gearbox, road speed of approximately 80% can be achieved when selected.
1. Vehicle engine Running. Parking brake ON, Neutral gear selected. Auxiliary engine ON . Refer to page 11.
2. Depress the clutch and press the switch on the main control panel. The symbol on the LCD screen will change to the symbol. The vehicle is now in reduction
drive mode.
If the reduction gearbox fails to engage the symbol will flash, Press the again to restore normal drive. Move the vehicle slightly forward and repeat the forgone
procedure.
3. Select the appropriate sweeping equipment. Refer to pages 11 and 12, and the best suited gear ratio for the prevailing sweeping conditions. Commence sweeping.
Disengaging the reduction gearbox (scarab option only)
1. With all sweeping equipment OFF and stowed, fan OFF. Vehicle Stopped. Parking brake On. Neutral selected.
2. Auxiliary engine OFF (allow two minutes idling first).
3. Depress the clutch and press on the main control panel. The symbol On the LCD screen will change to the symbol. The vehicle is now in normal drive mode.
If the reduction gearbox fails to engage the symbol will flash, Press the again to restore normal drive. Move the vehicle slightly forward and repeat the forgone
procedure.
To Next Page
Loading...
