Schaeffler Technologies
BA 68
31
The gateway is now connected.
If the mobile phone gateway connection is used (factory setting),
the gateway connects automatically with the Schaeffler IoT Hub.
Please remember that it can take several minutes to establish
the connection.
If the gateway is to be connected via the LAN, you can alternatively
establish communication with the gateway by plugging the
network cable connector into the router socket.
When the LED on the gateway flashes green then the connection
to the internet has been established successfully. The gateway
appears in the customer section in the Schaeffler IoT Hub.
If the mobile phone connection via the installed SIM card is not to be
used, there are other options available, see page 37:
■
SIM card provided by the customer
■
connection via WiFi
■
connection via network cable.
Install sensor
Danger of burns due to hot surfaces. The surface of a machine can
reach a temperature that can cause burns in the event of contact
with the hot surface. Switch the machine off and let it cool down
before you start installing the sensor. The surface temperature of
the machine has to be measured using suitable measuring
devices.
Please take note of the following for the mounting location:
■
Do not cover up the sensors to ensure that data transmission is
not impeded.
■
When choosing the mounting location, take care to avoid areas
exposed to stronger vibrations, such as the natural oscillation
of thin-walled housing covers or cooling fins.
Activate sensor before mounting
To activate the sensor you need an NFC-capable mobile phone or
tablet. The OPTIME app has to be installed on your mobile phone or
tablet.
To Next Page
Loading...
