108
SCClub operating instructions
Ambient temperature +5°C up to max. +35°C (drain the water
system in the event of frost).
Maximum humidity 80% relative humidity without condensation.
Do not use the device in the open.
Installation surface/Spray water The device must be installed on a level,
horizontal and rm surface which is water- and
heat-resistant.
The device must not be cleaned with a water
jet. The device must be installed where it is
protected from spray water. The device must
not be installed on a surface which is sprayed
or cleaned with a water hose, a steam jet
device, a steam cleaner or similar.
Set-up distances
For functional, service and safety reasons,
during installation a minimum distance of
50 mm is required between the machine
and sides of the building - or from parts not
manufactured by Schaerer - or at least 60 mm
between the machine and the rear wall.
A minimum work space in front of the coee
machine of 800 mm is recommended. Free
space of at least 200 mm above the product
container is recommended. The height of the
installation surface, starting from the upper
edge of the oor, must be at least 850 mm.
If the coee machine's connections are to
run downward through the counter, observe
the space requirements of the lines which
can restrict usable space in the structure
underneath.
Water lter set-up distances
See the operating instructions of the water
lter.
Set-up distances
Appendix: Technical data
To Next Page
Loading...
