Schaerer Coffee Club - Steamjet Cup Warmer

40
SCClub operating instructions
Software
5.2.2 SteamJet cup warmer
Risk of burns/
Danger of scalding
• Hot steam is output through the SteamJet
cup warmer. At the same time, the cups and
the adjacent surfaces are hot.
> Use heat-resistant drink containers.
> Always put a cup with the opening at the
bottom over the cup warmer before steam
is dispensed.
> Do not touch the adjacent surfaces shortly
after dispensing.
> Do not touch the outlets immediately after
dispensing.
> Never use the SteamJet function without
using a drip grid or the cup warmer insert.
Health risk/Hygiene
• The SteamJet function is intended for
warming up drink containers and is not
suitable for cleaning.
> Instead, use a freshly-rinsed drink
container to warm the cups.
The SteamJet cup warmer heats cuts with hot steam.
* Place a cup into the cup warmer with the opening
facing down.
* Tap the eld.
Hot steam slowly ows into the cup from below.
The steam ow is output as long as is specied in the
settings.
* Tap on the SteamJet eld again.
The steam ow immediately stops.
CAUTION
Observe the Safety chapter
w from page 9
Clean the drip tray daily
Care w from page 70
CAUTION
Observe the Safety chapter
w from page 9
SteamJet eld active/inactive
w Operating options
page 51