www.scheppach.com
GB
|
21
-
served.
arise due to non-observance of these instructions
2. Device description
1. Base plate
2. Pillar
3. Drilling table
4. Machine head
5. Drill chuck
6. Grips
7. Drill chuck protection
8. Depth stop
9. Motor
10.
11. Belt protective hood
12. Counternuts for belt tension
13. Laser module
13.1
13.2
14. Vice
C Vice fastening screws
E Table locking
F Allen screws
G Nut fastening, depth stop
H Philips screw, chuck guard
I Hole housing, depth stop
J Nut, depth stop
K Pointer, depth stop
L Groove
M Spring cap
N Inner nut
O Outer nut
P Hub
S Table locking
T Laser set screw
U Laser countersunk screw
V Belt guard screw
W Laser locknut
3. Scope of delivery
• Base plate
• Pillar
• Drilling table
• Machine head
• Drill chuck
•
1. Introduction
Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
and success.
Note:
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
•
technicians,
• Installation and replacement of non-original spare
parts,
•
•
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 570,813 /
VDE0113.
We recommend:
-
tions before installing and commissioning the device.
The operating instructions are intended to help the
user to become familiar with the machine and take
advantage of its application possibilities in accord-
ance with the recommendations.
The operating instructions contain important informa-
-
-
-
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
instructed concerning the operation of the machine and
who are informed about the associated dangers. The
minimum age requirement must be complied with.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
