www.scheppach.com
28
|
GB
13. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies
with the applicable VDE and DIN provisions. The
customer‘s mains connection as well as the ex-
tension cable used must also comply with these
regulations.
Important information
In the event of an overloading the motor will switch
motor can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been im-
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
not hang on the power network during the inspection.
-
nection cables of the same designation.
-
AC motor:
• The mains voltage must be 230-240 V~.
•
cross-section of 1.5 mm2.
• Connections and repairs of electrical equipment
Please provide the following information in the
event of any enquiries:
•
•
the drill.
of the drill tip.
Adjusting the spindle retaining spring (Fig. 9)
be adjusted because of changed tension, making the
1. To provide more space, lower the table.
2. Work on the left side of the drill.
3.
keeping it in place.
4.
5. Leaving the screwdriver in the notch, loosen the
6.
7. Lower the spindle to the lowest position and hold
moves up and down as desired, retighten the in-
8. If it is too loose, repeat steps 3-5. If it is too tight,
repeat in reverse order.
9. -
NOTE: Do not over-tighten and do not restrict the
movement of the spindle!
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: carbon brushes; V-belts, batteries, bits
12. Storage
and frost-proof place that is inaccessible to children.
The optimum storage temperature is between 5 and
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical tool.
To Next Page
Loading...
