www.scheppach.com
22
|
GB
Electrical safety
a) The electrical tool’s connection plug must t
into the socket.
Do not use an adaptor plug together with
earthed electric tools. -
able sockets reduce the risk of an electric shock.
b) Avoid body contact with earthed surfaces,
such as pipes, heaters, ovens and refriger-
ators. There is an increased risk of electric
shock if your body is earthed.
c) Keep electric tools away from rain and mois-
ture. Water entering an electric tool increases the
risk of an electric shock.
d) Do not use the cable for another purpose, for
example, carrying or hanging the electric tool
or pulling the plug out of the socket. Keep the
device parts. Damaged or coiled cables increase
the risk of an electric shock.
e) If you work with an electric tool outdoors,
only use extension cables that are also suit-
able for outdoor use.
suitable for outdoor use reduces the risk of an
electric shock.
f) If you cannot avoid using the electrical tool in
a wet environment, use a fault-current circuit
breaker. Using a fault-current circuit breaker re-
duces the risk of an electric shock.
Safety of personnel
a) Remain attentive, pay attention to what you
are doing and be sensible when working with
electric tools. Do not use an electric tool if
you are tired or under the inuence of drugs,
alcohol or medication. A moment of careless-
ness when using electrical tools can result in se-
rious injuries.
b) Wear personal protective equipment and al-
ways wear safety goggles. Protective equip-
hard hat or hearing protection used for appropri-
ate conditions will reduce personal injuries.
c) Avoid unintentional startup. Make sure that
the electric tool is switched o before you
connect it the power supply and/or battery,
pick it up or carry it.
that have the switch on invites accidents.
d) Remove the setting tools or spanners before
switching on the electric tool. A tool or spanner
in injuries.
e) Avoid abnormal posture. Make sure that you
have secure footing and always maintain your
balance.
• Drill chuck protection
• Grips
• Depth stop
•
•
• Laser module
• Operating manual
4. Intended use
The bench drill is designed for drilling in metal, wood,
plastic and tiles.
Chuck clamping range: 1.5 - 13 mm.
-
incorrect operation of this device.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial appli-
is used in commercial, trade or industrial businesses
or for equivalent purposes.
5. Safety information
General safety instructions for electric tools
m WARNING! Read all safety instructions, infor-
mation, illustrations and technical data for this
electric tool. Failure to observe the following infor-
mation and instructions can result in electric shock,
Store all safety instructions and information for
future reference.
Workplace safety
a) Keep your work area clean and well-lit. Dis-
organised or unlit work areas can result in acci-
dents.
b) Do not work with the electric tool in an explo-
sive environment where ammable liquids,
gases or dusts may be located. Electric tools
c) Keep children and other people away while
using the electric tool.
To Next Page
Loading...
