www.scheppach.com
GB
|
23
h) Keep the handles and gripping surfaces dry,
clean and free of oil and grease. -
dles and gripping surfaces prevent safe operation
and control of the electrical tool in unforeseen sit-
uations.
Service
a) Only have your electric tool repaired by qual-
ied specialists and only with original spare
parts.
is maintained.
Safety instructions for drills
a) The drill must be secured. -
cured drill can move or topple and this can result
in injuries.
b) The workpiece must be clamped or fastened
to the workpiece support. Do not drill into
workpieces that are too small to be securely
clamped.
lead to injuries.
c) Do not wear gloves.
rotating parts or drilling debris and thus cause in-
juries.
d) Keep your hands away from the drilling area
whilst the electrical tool is running. Contact
with rotating parts or drilling debris can cause in-
juries.
e) The drill must be turning before it makes con-
tact with the workpiece. Otherwise, the drill bit
can catch in the workpiece and this can result in
cause injuries.
f) If the drill becomes jammed, stop pressing
downwards and switch the electrical tool
o. Investigate and rectify the cause of the
jamming.
movement of the workpiece and can result in se-
rious injuries.
g) Avoid long pieces of drill swarf by interrupt-
ing the downward pressure at regular inter-
vals. Sharp metal swarf can become tangled and
lead to injuries.
h) Never remove drilling debris from the drilling
area whilst the electrical tool is running. To
remove swarf, move the drill away from the
workpiece, switch o the electrical tool and
wait until the drill has come to a standstill.
Use an aid such as a brush or a hook to re-
move the swarf. Contact with rotating parts or
drilling debris can cause injuries.
i) The permissible rotational speed for drill bits
with a rated speed must be at least as high as
the highest speed cited on the electrical tool.
Accessories that rotate faster than permitted can
f) Wear suitable clothing. Do not wear wide
clothing or jewellery. Keep hair, clothing and
gloves away from moving parts. Loose cloth-
-
ing parts.
g) If dust extraction and collection devices can
be mounted, make sure that they are connect-
ed and used properly.
h) Do not allow yourself to be lulled into a false
sense of security and do not ignore the safety
rules for electric tools, even when you have
used them many times and have become fa-
miliar with them. Careless actions can result in
serious injuries within a fraction of a second.
Using and handling the electric tool
a) Do not overload the device. Use the electric tool
The suitable electric tool
indicated power range.
b) Do not use an electric tool whose switch is
defective. An electric tool that cannot be
switched on or o is dangerous and must be
repaired.
c) Remove the plug from the socket and/or take
out a removable battery before setting the
device, changing insertion tool parts or put-
ting the electric tool away.
measures will prevent the electric tool from start-
d) Keep unused electric tools out of the reach of
children. Do not let people use the electric tool
who are not familiar with it or who have not read
these instructions. Electric tools are dangerous if
e) Maintain electric tools and tool attachments
with care. Check whether moving parts function
Have damaged
parts repaired before using the electric tool.
-
tric tools.
f) Always keep cutting tools sharp and clean.
Carefully maintained cutting tools with sharp
cutting edges seize up less often and are eas-
ier to guide.
g) Use electric tools, accessories, insertion tool,
etc. according to these instructions. Take the
out into consideration. Using electric tools for ap-
plications other than the intended uses can lead
to dangerous situations.
To Next Page
Loading...
