www.scheppach.com
GB
|
27
Warning:
To prevent the workpiece or the backup material from
to the left side of the column. If the workpiece or the
backup material are not long enough to reach the col-
umn, clamp them to the table. Failure to do this could
Note: For small pieces that cannot be clamped to the
table, use a drill press vise.
The vice must be clamp or bolt to the table to avoid
Mounting the machine vice on the drilling table
Fasten the machine vice using the screws, washers
and nuts provided, as shown in Fig. 13.
Using the laser (Fig. 15, 16)
Replacing the battery:
-
with new batteries.
To switch on:
switch on the laser.
Two laser lines are projected on the workpiece and
intersect at the centre of the drill tip contact point.
To switch o:
Working speeds
is dependent on the diameter of the drill bit and the
material in question.
The table below acts as a guide for selecting the
proper speed for various materials.
-
ues.
Drill
bit Ø
Cast
iron
Steel Iron Alumin-
ium
Bronze
3 2550 1600 2230-
240
9500 8000
4 1900 1200 1680 7200 6000
5 1530 955 1340 5700 4800
6 1270 800 1100 4800 4000
7 1090 680 960 4100 3400
8 960 600 840 3600 3000
9 850 530 740 3200 2650
10 765 480 670 2860 2400
11 700 435 610 2650 2170
12 640 400 560 2400 2000
13 590 370 515 2200 1840
14 545 340 480 2000 1700
16 480 300 420 1800 1500
Countersinking and centre-drilling
-
tre-drill. Please observe that countersinking should
be performed at the lowest speed, while a high speed
is required for centre-drilling.
Drilling wood
when working with wood, as it can pose a health haz-
performing work that generates dust.
10. Transport
guards or adjusting handles for transport.
For transport, the machine must be disconnected
from the mains.
11. Cleaning and Servicing
Pull the mains plug before any adjustments,
maintenance or repair.
m Have any work on the device that is not de-
scribed in this instruction guide performed by a
professional. Only use original parts. Allow the
device to cool o before any maintenance or
cleaning is undertaken.
There is a risk of burning!
-
ous defects such as loose, worn or damaged parts,
-
change the damaged parts.
• -
ical substances can etch the plastic parts of the de-
vice. Never clean the device under running water.
•
• Clean the ventilation openings and the surface of
the device with a soft brush or cloth.
• Remove chips, dust and dirt with a vacuum cleaner
•
• Do not allow lubricants to come into contact with
WARNING:
adjustment“.
Setting the laser (Fig. 15, 16)
drill. If the laser line does not meet in the centre of the
drill, the laser must be adjusted.
To Next Page
Loading...
