www.scheppach.com
24
|
GB
6. Technical data
Nominal input voltage
230-240 V∼/50 Hz
Power rating
Motor speed 1450 min
-1
Output speed
600 min
-1
900 min
-1
1300 min
-1
1800 min
-1
2650 min
-1
Drill chuck mount B16
Drill chuck 1,5 - 13 mm
Dimensions of drill table
Angle adjustment of table 45°/0°/45°
Drill depth 50 mm
Pillar diameter 46 mm
Height 600 mm
Base area
Weight 13,5 kg
Laser class II
Wavelength of laser 650 nm
Laser output < 1 mW
*
Noise and vibration values
The total noise values determined in accordance with
EN 62841.
Sound pressure level L
pA
pA
3 dB
Sound power level L
WA
WA
3 dB
Wear hearing protection.
-
mined in accordance with EN 62841.
2
2
-
change according to how the electric equipment is
-
tional circumstances.
the equipment with other electric power tools.
Attention: Laser radiation
Do not look into the beam
Laser class 2
Protect yourself and you environment from acci-
dents using suitable precautionary measures!
• -
• Never look into the path of the beam.
• -
faces and persons or animals. Even a laser beam
•
• Never open the laser module. -
sure to the beam can occur.
•
of laser.
•
laser manufacturer or an authorised representa-
tive.
• Labelling and placement of warning stickers, see
m WARNING! This electric tool generates an elec-
-
pair active or passive medical implants under certain
conditions. In order to prevent the risk of serious or
manufacturer of the medical implant prior to operat-
ing the electric tool.
Residual risks
Even if you use this electric power tool in accord-
ance with instructions, certain residual risks
cannot be eliminated. The following hazards may
arise in connection with the equipment’s con-
struction and layout:
• Lung damage if suitable dust protection mask is not
worn.
• Hearing damage if suitable hearing protection is
not worn.
• Damage to health resulting from hand/arm vibra-
To Next Page
Loading...
