OPERATION
XH1500/XH1000 06-24 Operation Section 4-26
OPERATION
© 2024 Alamo Group Inc.
TRACTOR PRE-OPERATION INSPECTION
Tractor ID#___________________________
Date:_______________________________
Make :______________________________
Shift:_______________________________
Before conducting the inspection, make sure the tractor engine is off, all rotation has stopped
and the tractor is in park with the parking brake engaged. Make sure the implement is resting
on the ground or securely blocked up and all hydraulic pressure has been relieved.
Operator’s Signature: ___________________________________________
Item
Condition
at Start of Shift
Specific Comments
if not OK
The flashing lights function properly
The SMV Sign is clean and visible
The tires are in good condition with proper pressure
The wheel lug bolts are tight
The tractor brakes are in good condition
The steering linkage is in good condition
There are no visible oil leaks
The hydraulic controls function properly
The ROPS or ROPS Cab is in good condition
The seatbelt is in place and in good condition
The 3-point hitch is in good condition
The drawbar pins are securely in place
The PTO master shield is in place
The engine oil level is full
The brake fluid level is full
The power steering fluid level is full
The fuel level is adequate
The engine coolant fluid level is full
The radiator is free of debris
The air filter is in good condition
Proper hourly greasing is done per Operator’s Manual
DO NOT OPERATE an UNSAFE TRACTOR or IMPLEMENT
To Next Page
Loading...