1.7 Safety arrangements at the workspace
Set-up and installation of the device has to be done under supervision of an authorized person. Depending on the weight of the machine, the
installation has to be done by 4 persons. The machine should be situated on the flat, non-inflammable surface, in a room with constant
temperature and moisture. Keep the machine away from dusty rooms, because dust could have a negative influence on some parts of the
machine. Very important! The machine may be connected only to an installation provided with a protection differential current and against electric
shock. Instruction of mounting the machine is in the chapter 3. The machine is delivered with an E-The machine is destined for industrial use only.
type (european) plug.
Set-up installation
After the correct installation of the machine it is important to ensure that the machine works properly, it's not damaged after the transportation and
has no safety defects. The testing can only be done by the employer or other authorized persons. It is mandatory to guarantee a correct installation
and safe usage of the machine. The testing should be protocoled. If any irregularities regarding functionality or safety are found during the testing,
these have to be notet and reported to Walter Schulze GmbH in written form within 7 days. Until the clarification the machine cannot be used.
Information and education
Safety arrangements
Testing the machine
The advice from he producer and general safety arrangements at the workplace, the employer has to make arrangements to give all information
about the safety, function and the range of application to the user. In particular the user needs to be acquainted with the complete manual and be
explicitly informed of the dangers of working with the machine. The details have to be explained in a coherent form and language. Every user is
obligated to a safe usage of the machine and to read the manual instruction before each operator starts working with the machine.
In order to ensure optimized safety, please read the manual instruction precisely. Only one person is allowed to work on the machine at the time.
The machine has to be under supervision the whole time, when it is working. Supervise the machine till it is switched off and the plug is pulled out.
There should be no unauthorised persons near the machine while it’s working. In case of emergency push the red emergency button situated on
the control desk. The machine will stop immediately. The machine has to be installed at a place with enough space around the machine to put the
material on. Do not install the machine in doors, floors or busy places. All wires should be placed in a safe way, to make sure they will not pose a
threat for the person working on the machine or passing it. In case of damages of the wires or untypical signals from the machine please
disconnect the machine from the power supply, contact the service and do not work with the machine, till the problem is solved. All repairs should
be performed after consulting the service. Do not make any repairs on your own. Do not remove machine covers while it is working.
Correct position of the operator
The operator needs enough space and free distance to all switches and buttons to work with the machine. Safe position allows operator to switch
on the emergency button in every moment.
Other risks and dangers
There are some movable elements on the machine, which can cause injuries of hands or fingers. For reasons of workability, these elements
cannot be eliminated. They can cause injuries/ mash / burn fingers or hands.The dangerous zones are marked with the caution labels. It is
important to work with the machine with great care and be alert to avoid other dangerous situations. The machine complies with the essential
requirements laid down in regulation for machines. Above information has been worked out in accordance with the standards PN-EN 12100:2012.
The machine is continuously upgraded to improve its safety. Any comments on the contents of this manual can be addressed to the distributor or
manufacturer.
Printer
minimum 60 cm
minimum 100 cm
Correct operating position (plan view)
ENGLISH
22
Version 23.05
1.8 Environmental protection
The packaging of the device must be disposed of in accordance with the applicable rules. Do not dispose of the equipment marked with an
together with your household waste. No longer needed machines may be returned to the manufacturer or disposed of in an environmentally
friendly manner by means of appropriate disposal systems.
To Next Page
Loading...