Maintenance
06.00 | DRG | Assembly and operation manual | en | 389041 31
7 Maintenance
7.1 Notes
Original spare parts
Use only original spare parts of SCHUNK when replacing spare and
wear parts.
7.2 Maintenance and lubrication intervals
CAUTION
Material damage due to hardening lubricants!
Lubricants harden more quickly at temperatures above 60°C,
leading to possible product damage.
l
Reduce the lubricant intervals accordingly.
Size 44 - 100
Interval [Mio. cycles] 2
7.3 Lubricants/Lubrication points (basic lubrication)
During maintenance, treat all greased areas with lubricant.
Thinly apply lubricant with a lint-free cloth.
SCHUNK recommends the lubricants listed.
Greasing area Lubricant
Metallic sliding surfaces Rivolta F.L.G. GT-2
All seals Rivolta F.L.G. GT-2
Bore hole at the piston Rivolta F.L.G. GT-2
The product contains food-compliant lubricants as standard.
The requirements of standard EN1672-2:2020 are not fully met.
NOTE
l
Change contaminated food-compliant lubricant.
l
Observe information in the safety data sheet from the
lubricant manufacturer.
To Next Page
Loading...
Need help?
General
