Basic safety notes
06.00 | DRG | Assembly and operation manual | en | 389041 9
l
Execute the gripper fingers in such a way that the product
reaches either the "open" or "closed" position in a de-
energized state.
l
Only change gripper fingers if no residual energy can be
released.
l
Make sure that the product and the top jaws are a sufficient
size for the application.
2.5 Ambient conditions and operating conditions
Required ambient conditions and operating conditions
Incorrect ambient and operating conditions can make the
product unsafe, leading to the risk of serious injuries,
considerable material damage and/or a significant reduction to
the product's life span.
l
Make sure that the product is used only in the context of its
defined application parameters, }3 [/16].
l
Make sure that the product is a sufficient size for the
application.
l
Make sure that the environment is free from splash water and
vapors as well as from abrasion or processing dust. Exceptions
are products that are designed especially for contaminated
environments.
2.6 Personnel qualification
Inadequate qualifications of the personnel
If the personnel working with the product is not sufficiently
qualified, the result may be serious injuries and significant
property damage.
l
All work may only be performed by qualified personnel.
l
Before working with the product, the personnel must have
read and understood the complete assembly and operating
manual.
l
Observe the national safety regulations and rules and general
safety instructions.
The following personal qualifications are necessary for the
various activities related to the product:
Trained electrician
Due to their technical training, knowledge and experience,
trained electricians are able to work on electrical systems,
recognize and avoid possible dangers and know the relevant
standards and regulations.
To Next Page
Loading...
Need help?
General
