Assembly
22 06.00 | DRG | Assembly and operation manual | en | 389041
5.3 Mounting the sensor
NOTE
Observe the assembly and operating manual of the sensor for
mounting and connecting.
The product is prepared for the use of sensors.
l
For the exact type designations of suitable sensors, please see
catalog datasheet and }5.3.1 [/22].
l
For technical data for the suitable sensors, see assembly and
operating manual and catalog datasheet.
– The assembly and operating manual and catalog
datasheet are included in the scope of delivery for the
sensors and are available at schunk.com.
l
Information on handling sensors is available at schunk.com or
from SCHUNK contact persons.
5.3.1
Overview of sensors
Designation DRG
44 54 64 80 100
Inductive proximity
switch IN 40
X X X X -
Inductive proximity
switch IN 80
X X X X X
Magnetic switch MMS 22 X X X X X
5.3.2 Mounting inductive proximity switch IN
Mounting kit To use the inductive sensor, the gripper has to be retrofitted with
a special mounting kit. This mounting kit is available from
SCHUNK for the models below.
Assembly IN
To Next Page
Loading...
Need help?
General
