SCHUNK DRG 44 - Servicing and Assembling the Product

Maintenance
34 06.00 | DRG | Assembly and operation manual | en | 389041
7.5 Servicing and assembling the product
Maintenance
l
Clean all parts thoroughly and check for damage and wear.
l
Treat all greased areas with lubricant.
}7.3 [/31]
l
Oil or grease bare external steel parts.
l
Replace all wear parts / seals.
– Position of the wearing parts }7.6 [/38]
– Seal kit }1.4 [/7]
Assembly
Assembly takes place in the opposite order to disassembly.
Observe the following:
l
Unless otherwise specified, secure all screws and nuts with
Loctite no. 243 and tighten with the appropriate tightening
torque.Link Anzugsmoment für Schrauben
l
Use a cylinder piston assembly device for mounting the sizes
DRG 44 to 100. }7.5.1 [/35]Drawings and dimensions of an
assembly device}7.5.2 [/36].