Maintenance
11.00 | EGP | Assembly and Operating Manual | en | 389476
43
8.2 Lubricants and lubricating points
SCHUNK recommends the listed lubricant.
During maintenance, treat all greasing areas with lubricant. Apply
a thin film of lubricant using a lint-free cloth or brush.
Lubricant point Lubricant
Metallic sliding surfaces Isoflex-Topas NCA 52
Position of the lubricating points
8.3 Disassembly and assembling
This product must not be disassembled for maintenance.
CAUTION
Material damage due to improper disassembly!
Incorrect works can cause damage to the mechanics and internal
electronics.
• Disassembly or opening of the product is not permitted.
• Only allow SCHUNK to repair the product.
To Next Page
Loading...