Operation
01.00 | FPS-F5 | Assembly and Operating Manual | en | 15959911 25
6.2.3 Connection options
6.2.3.1 Connect the electronic processor to the higher-level control
system
n An operating system Windows is available on the computer of
the higher-level controller
1. Open the cover of the electronic processor.
2. Plug the adapter cable into the serial interface of the
electronic processor.
3. Plug the socket of the adapter cable into the serial interface
of the computer.
4. Connect the voltage supply to the electronic processor.
5. Install the Gateway and FPS-Controller programs.
6. Integrate the required commands into the higher-level
control system.
6.2.3.2 Connecting the electronic processor to the computer
n Windows operating system is available on the computer
1. Open the cover of the electronic processor.
2. Plug the adapter cable into the serial interface of the
electronic processor.
3. Plug the socket of the adapter cable into the serial interface
of the computer.
4. Connect the voltage supply to the electronic processor.
5. Install the Gateway and FPS-Controller programs.
6. Enter the COM port in the INI file of the gateway
(TCPIP_RS232_GW.ini) and save the file.
7. Start Gateway.
8. Start FPS Controller.
ð A login window appears, }6.3.2 [/29].
9. Enter password if required.
10. Select network, enter IP address 127.0.0.1 and press OK.
ð The program window opens and the Programming
function is displayed, }6.3.3 [/29].
To Next Page
Loading...
