SCHUNK FPS Series - Page 27

Operation
01.00 | FPS-F5 | Assembly and Operating Manual | en | 15959911 27
atx0 confirm with Enter Dialing routine
at&d0 Ignore DTR signal
ats0=1 pick up after the first
ring
ats23=27 Baud rate to 9600
bps
at&w Save permanently
1. Connect the modem cable to the telephone socket.
2. Connect the adapter cable of the electronic processor to the
modem, use a 9-pin to 25-pin adapter if necessary.
3. Connect the remote maintenance computer to the telephone
network via the modem.
4. Start the Gateway program.
5. Start the FPS Controller program.
ð A login window appears, }6.3.2 [/29].
6. Enter password if required.
7. Select the modem, enter the telephone number of the
modem to which the evaluation unit is connected, enter the
IP address 127.0.0.1 and press OK.
IMPORTANT!If an outside line is required, a 0 must be
entered before the telephone number.
ð The program window opens and the Programming
function is displayed, }6.3.3 [/29].