Operation
30 01.00 | FPS-F5 | Assembly and Operating Manual | en | 15959911
1. By pressing the Learn current gripper value buttons, the
current position value at the time the button is pressed is
entered in the input field below Values input in mm.
2. If the input values are known, they can also be entered
directly in the Values input in mm input fields.
NOTE
If there is no value in one of the fields (empty field), the
corresponding value remains stored and unchanged in the input
memory of the electronic processor. This makes it possible to
change only a single value.
3. Pressing the Transfer values to FPS button saves the values
entered in the electronic processor input memory but does
not yet activate them as new switching points.
ð Electronic processors work with the old switching points.
4. If the Save as switching point button is pressed, the values of
the input memory are written directly to the working memory
of the electronic processor.
ð From this point on, the electronic processor will work
with these new switching points.
5. Or: If the Save as range button is pressed, the values of the
input memory are written to the working memory of the
electronic processor so that the switching point is always
exactly in the middle between two values of the input
memory. This results in previously taught-in parts being
optimally differentiated from one another.
ð From this point on, the electronic processor will work
with these new switching points.
To Next Page
Loading...
