Assembly
22 14.00 | GSM-P | Assembly and Operating Manual | en | 389104
3. Connect the product via the hose-free direct connection.
ð Use O-rings from the accessory pack.
ð Seal main air connections which are not required with
locking screws.
4. OR: Connect compressed air lines to the main air
connections"A" and"B".
ð Screw in air connections (plug connections).
OR: Screw on throttle valve in order to be able to perform
sufficient throttling and/or damping.
5. Screw the product to the machine/system, }5.2.1 [/23].
ð If necessary, use appropriate connection elements
(adapter plates).
ð Observe the maximal tightening torque, admissible
screw-in depth and, if necessary, strength class.
ð When mounting from the rear or at the side: use
cylindrical pins for fixing the product in place.
6. Secure the gripper fingers to the base jaws, }5.2.1 [/23].
ð Use centering sleeves from the enclosed accessory pack.
7. Connect air purge connection if necessary.
8. Connect the sensor, see assembly and operating manual of
the sensor.
9. Mount the sensor, }5.3 [/27].
To Next Page
Loading...
