Maintenance
14.00 | GSM-P | Assembly and Operating Manual | en | 389104 47
8.5 Disassembly/assembly of the unit in the basic modules
Position of the item numbers, }8.12 [/57]
Disassembly
1. Remove the compressed air lines.
2. Turn the gripping module (GSM) into the middle position.
3. Remove the screws (104) and pull the feed-through compact
module DKM (40) off the rotor drive FAN (50).
Assembly
1. Turn the rectangular section of the rotor drive (53) with the
longer side towards the center of the air connections A and B.
2. Turn the stop 1 DKM (81) with the magnet towards the 90°
position, i.e. with the 090 version, one magnet has to point
towards the 90° position and the other one towards the 180°
position.
3. Put the feed-through compact module DKM (40) on the rotor
drive FAN (50) and secure the two modules with the screws
(104). Observe permissible tightening torques, }8.4 [/46].
To Next Page
Loading...
