Maintenance
56 14.00 | GSM-P | Assembly and Operating Manual | en | 389104
8.11 Servicing and assembling the product
Maintenance
l
Clean all parts thoroughly and check for damage and wear.
l
Treat all greased areas with lubricant.
}8.3 [/44]
l
Oil or grease bare external steel parts.
l
Replace all wear parts / seals.
– Position of the wearing parts }8.12 [/57]
– Seal kit }1.4.1 [/8]
Assembly
Assembly takes place in the opposite order to disassembly.
Observe the following:
l
Unless otherwise specified, secure all screws and nuts with
Loctite no. 243 and tighten with the appropriate tightening
torque.}8.4 [/46]
To Next Page
Loading...
