SCHUNK GSM-P - Page 52

Maintenance
52 14.00 | GSM-P | Assembly and Operating Manual | en | 389104
6. For elastomer variants, proceed as follows:
Remove the stops (83) after loosening the nuts (124).
Also remove the needle rollers (122).
7. For shock absorber variants, continue as follows:
Remove the shock absorber (120) after loosening the nuts
(121).
Also remove the sleeves (122).
Assembly For assembly, observe the permissible tightening torques as well
as the greases and adhesives to be used, }8.4 [/46] and }8.3
[/44].
1. Grease the (11) housing DKM GSM and the bushing (44 or 46)
on the running surfaces and bearings.
2. Grease the bearing ring (82).
3. Insert the bearing ring with the outer chamfer downwards
into the housing DKM GSM.
4. Grease the O-rings (103) and install them in the recesses on
the bushing (44 or 46).
5. Insert the gripping module into the housing DKM GSM.
6. Match up the axial bearing seat of the bushing with the
fitting disks (111 or 112).
7. Place stop 1 DKM (81) onto the bushing and fasten it to the
bushing using the screws (140).
8. Grease the ball guide DKM (85).
9. Turn the bushing so that stop 1 DKM (81) is pointing 180° away
from the bore holes for the dampening unit.
10. Grease the needle rollers (122) and put them into the
appropriate fits.
11. For elastomer variants, proceed as follows:
Grease the needle rollers (122) and put them into the
appropriate fits.
Place one ball (142) in the housing in front of each needle roller
(122) and screw the stop 2 DKM (83) into the housing.
12. For shock absorber variants, continue as follows:
Grease the sleeves (122) and put them on the shock absorbers
(120). Insert the sleeve into the fit provided in the housing
DKM GSM (11) and screw the shock absorber into the housing.
Place one ball (142) in the housing in front of each sleeve
(122).
13. Mount the counter nut (124) onto the stops/shock absorbers.
14. Connect the DKM module (11) to the rotor drive FAN using the
screws (104). When doing this, pay attention to the assembly
of the basic modules, }8.5 [/47].