SCHUNK SVH - Declarations and Regulations; EC Declaration of Incorporation

Translation of the original declaration of incorporation
28 04.00 | SVH | Assembly and Operating Manual | en | 389734
9 Translation of the original declaration of
incorporation
in terms of the Directive 2006/42/EG, Annex II, Part 1 Section B.
Manufacturer/
Distributor
SCHUNK SE & Co. KG
Toolholding and workholding | Gripping Technology | Automation
technology
Bahnhofstr. 106 - 134
D-74348 Lauffen/Neckar
We hereby declare that the partly completed machine described below
Product designation: Servo-electric 5-Finger Gripping Hand / SVH / electric
ID number 1545589, 1545592
meets the following basic occupational health and safety of the Machinery Directive 2006/42/EC:
No. 1.1.1, No. 1.1.2, No. 1.1.3, No. 1.1.5, No. 1.3.2, No. 1.5.1, No. 1.5.2; No. 1.5.4, No. 1.5.6,
No. 1.5.8, No. 1.5.10, No. 1.5.11, No. 1.5.13
The partly completed machinery may not be put into operation until it has been confirmed
that the machine into which the partly completed machinery is to be installed complies with
the provisions of the Machinery Directive (2006/42/EC). The declaration shall be rendered
invalid if modifications are made to the product.
Applied harmonized standards, especially:
EN ISO 12100:2010 Safety of machinery - General principles for design -
Risk assessment and risk reduction
EN ISO 13849-1:2015 Safety of Machinery – Safety-relevant parts of control systems –
Part 1: General design approaches
EN ISO 13849-2:2012 Safety of Machinery – Safety-relevant parts of control systems –
Part 2: Validation
The special technical documentation according to AnnexVII, Part B, belonging to the partly
completed machine, has been created.
Person authorized to compile the technical documentation:
Stefanie Walter, Address: see manufacturer's address
Lauffen/Neckar, May 2023 Dr.-Ing. Manuel Baumeister,
Head of Systems Engineering,
Technology & Innovation