UKCA declaration of incorporation
04.00 | SVH | Assembly and Operating Manual | en | 389734 29
10 UKCA declaration of incorporation
in accordance with the Supply of Machinery (Safety) Regulations 2008.
Manufacturer/
Distributor
SCHUNK Intec Limited
Clamping and gripping technology
3 Drakes Mews, Crownhill
MK8 0ER Milton Keynes
We hereby declare that on the date of the declaration the following partly completed machine
complied with all basic safety and health regulations found in the
"Supply of Machinery (Safety) Regulations 2008".
The declaration shall be rendered invalid if modifications are made to the product.
Product designation: Servo-electric 5-Finger Gripping Hand / SVH / electric
ID number 1545589, 1545592
The partly completed machine may not be put into operation until it has been confirmed that
the machine into which the partly completed machine is to be installed complies with the
provisions of the "Supply of Machinery (Safety) Regulations 2008".
Applied harmonized standards, especially:
EN ISO 12100:2010 Safety of machinery - General principles for design -
Risk assessment and risk reduction
EN ISO 13849-1:2015 Safety of Machinery – Safety-relevant parts of control systems – Part 1:
General design approaches
EN ISO 13849-2:2012 Safety of Machinery – Safety-relevant parts of control systems – Part 2:
Validation
The special technical documentation according to AnnexVII, Part B, belonging to the partly
completed machine, has been created.
Person authorized to compile the technical documentation:
Marcel Machado, address: refer to manufacturer's address
Lauffen/Neckar, May 2023 Dr.-Ing. Manuel Baumeister,
Head of Systems Engineering,
Technology & Innovation
To Next Page
Loading...