Basic safety notes
8 04.00 | SVH | Assembly and Operating Manual | en | 389734
2 Basic safety notes
2.1 Intended use
The product features a multi-functional design intended for
gripping objects ranging from 1-850 g.
It is important to ensure that no fragile, sharp or sharp-edged
objects, or objects with an edge length of over 50 cm are
handled.
l
Gripping objects of a higher weight is only permitted after
consultation with the manufacturer.
l
The product is intended for installation in a machine. The
requirements of the applicable guidelines and standards must
be observed and complied with. If applicable, it may be
required to provide proof of safety for the machine to be
used. The safety features of this product were established/
certified only for use as described in this operating manual.
The safety-related information contained in the "Electrical
equipment of machines" standard (DIN EN 60204) must be
observed. Commissioning is only permitted in compliance with
EMC directives (2014/30/EU) and the Electromagnetic Compatibility
Regulations 2016.
l
The product may only be used within the scope of its technical
data, }3 [/15].
l
The product is intended for industrial and industry-oriented
use.
l
For appropriate use of this unit, it is essential to observe the
technical data and assembly and operation notes in this
manual and to comply with the maintenance intervals.
2.2 Consequences of inappropriate use
The safety of the product cannot be guaranteed in the event of
inappropriate use (i.e. actions carried out in a manner that is not
compliant with this operating manual). It is possible for the
safety of this product to be permanently impaired/damaged as
the result of one single inappropriate use.
Examples of inappropriate use include the product being used as
a press tool, being overloaded, or being used in an environment
that is not low-dust/dry.
To Next Page
Loading...