Scireq flexivent - Power; Workstation or Network; Transducers and Accessories

29
2.4.1 POWER
Disengage the motor lock before connecting a power source. Refer to section 2.3 for
details.
The power cord used should comply with local standards.
Use only the power supply provided by SCIREQ with the flexiVent system.
Ensure that the motor lock is disengaged. Connect the power supply to the appropriate location
on the controller module. Plug the power supply into a standard wall outlet using the
appropriate cord.
2.4.2 WORKSTATION OR NETWORK
Connect an Ethernet cable to the Ethernet port on the controller module. Connect the other end
of the cable to a server, data acquisition workstation or network port. The appropriate
connection for the Ethernet cable varies with the complexity of your
UnitWise system.
2.4.3 TRANSDUCERS & ACCESSORIES
Connect transducers and accessories (e.g. UNIT Aeroneb adapter cable) to the auxiliary ports
found on the controller module. Selection of the appropriate port is determined by the template
selected for experimentation, and a prompt will appear during the start-up sequence of
experimentation denoting the appropriate configuration. A selection of configurations is
provided in Table 2-1; for configurations including hardware extensions or custom applications,
refer to documentation that accompanies the hardware or information supplied by SCIREQ
Technical Support.